10 連接埠 L2+ 全網管 PoE++ 交換器,含 8 個 Gigabit 乙太網路連接埠及 2 個 SFP Uplinks
10 連接埠 L2+ 全網管 PoE++ 交換器,含 8 個 Gigabit 乙太網路連接埠及 2 個 SFP Uplinks
符合 IEEE 802.3bt (4PPoE) 标准(2 x 90 W 端口,6 x 30 W 端口),242 W PoE 功率预算,第 2+ 层/第 3 层精简版,两个 1G SFP 开放式插槽,自愈式网络,台式机格式,包括可选的 19" 机架安装支架
存貨單位 (SKU):562003 IPS-10GM02-242W
分享

可摺疊的內容
概述
PoE++ IEEE 802.3bt L2+ 全管理型交換器– 具備兩個Gigabit上行鏈路與自我修復網路功能
Intellinet Network Solutions推出的10埠L2+全管理型PoE++交換器,擁有8個 Gigabit 端口與2個SFP上行鏈路,是中小企業和大型企業的首選利器。兩個10/100/1000BASE-T 4PPoE (PoE++)端口提供高達90瓦電力,即使是耗電量極高的設備,如瘦客戶機、POS系統或PTZ高速球型攝影機,也能輕鬆應對。額外六個PoE+ Gigabit 端口,每個端口可提供高達30瓦,完美支援IP電話和網路攝影機等設備。任何符合IEEE 802.3bt/at/af標準的設備連接至交換器後,無需額外供電,減少了電氣重新佈線的時間和成本,並降低了天花板和牆面上電源供應器與適配器的雜亂程度。此管理型交換器支持任意混合PoE和非PoE設備,並憑藉短路、過載與高壓保護功能,全面守護您的網路設備安全。
自我修復網路,提升可靠性與穩定性 – Intellinet智慧設備監控 (PDM)
這款管理型PoE交換器配備智慧設備監控(Powered Device Monitoring),具備自我修復功能。內建PoE看門狗(PoE Watchdog)可對所有連接的受電設備(PD)進行存活檢查,並自動重置無響應的設備,例如PoE監控攝影機,透過斷電並恢復供電讓設備重新啟動。PDM功能特別適用於設備對網路運行至關重要的應用場景,如工業或監控環境。此外,PD Alive功能可降低不必要的技術支援電話與昂貴的現場維護成本,因為設備的功能性重啟通常能夠讓無響應設備重新上線,節省人力與資源。
網頁管理,全面掌控網路
這款管理型交換器擁有強大的進階管理功能,讓您對網路保持全面掌控。它支援VLAN、端口聚合、QoS、端口鏡像、SNMP V1與流行的V2c等多項功能。此外,它兼容Domotz平台,實現更輕鬆的雲端管理。
PoE管理,精準供電
這款管理型交換器提供多項PoE管理功能。端口延遲啟動功能可減少系統啟動時的電力浪湧,而PoE優先級功能(低、中、高)允許您為關鍵任務端口設置優先權,即使交換器的供電預算超出,也能確保高優先級端口持續供電。此外,您還可設置每個端口的最大可用電力,獨立控制每個端口的PoE開啟與關閉,並監控所有連接PoE設備的即時功率消耗。該交換器還可通過SNMP-Traps發送警報,當總功耗超過使用者設定的閾值時,提醒網路管理員。
消除網路瓶頸,配備十個 Gigabit 端口
這款交換器配備共10個 Gigabit 端口,大幅提升資料傳輸能力,解決網路瓶頸問題,讓企業網路保持高速穩定運行。
配備八個自動感應的10/100/1000 Mbps RJ45 Gigabit 乙太網端口,這款交換器為您的電腦、伺服器和其他網路設備提供強勁性能。此外,兩個小型可插拔GBIC模組插槽(SFP)提供光纖連接,滿足更遠距離的網路需求。這些並非共用的組合端口,而是真正的 Gigabit 端口,將總可用頻寬提升至高達20 Gbps,全面釋放網路潛能,讓您的業務暢行無阻!
產品特性
- Provides up to eight PoE network devices with power and data
- Two 1G small form-factor pluggable (SFP) module slots
- Self-Healing Network - the Powered Device Monitor feature (PDM), also known as PD Alive Check, restarts any connected PoE device that fails to respond or send out network traffic
- Domotz compatible for cloud management
- PoE power budget of 242 watts
- PoE++ output up to 90 watts on ports 7 and 8 ; PoE+ output up to 30 watts on ports 1 through 6
- Supports 802.1Q VLAN (tag-based and port-based)
- 10/100/1000 auto-sensing ports that automatically detect optimal network speeds
- Supports IEEE 802.3bt/at/af-compliant PoE devices (wireless access points, VoIP phones, IP cameras and more)
- Supports IEEE 802.3bt/at/af detection and short circuit, overload and high-voltage protection
- All RJ45 ports with Auto-MDIX and NWay auto-negotiation support
- 20 Gbps switch fabric / switching capacity
- SNMP Management and Remote Monitoring (RMON)
- IPv4/v6 dual protocol
- Supports link aggregation (trunking)
- IGMP Snooping for multicast filtering
- Supports bandwidth control per port
- Supports port mirroring
- Supports two types of QoS: CoS and DSCP
- Broadcast storm control with multicast packet rate settings
- Supports jumbo frames up to 9216 Bytes
- Store and forward switching architecture
- Full/half duplex operation
- Supports 802.3x flow control for full duplex mode and collision-based backpressure for half duplex mode
- Supports 8k MAC address entries with Auto-learning and Auto-aging
- Buffer memory of 4.1 Mbits
- Grounding point to protect equipment from external electrical surges
- PoE surge protection (4 kV) for all RJ45 ports
- ESD protection up to 8 kV for air and 4 kV for contact
- Configuration via Web browser, Telnet, SSH or RJ45 console port
- LEDs for power, link/activity, PoE and system
- One high-efficiency fan for quiet, reliable cooling
- Includes 19" rackmount brackets
- Fully NDAA-compliant
- Three-year warranty
規格
Standards
- IEEE 802.1p (Traffic Prioritization)
- IEEE 802.1q (VLAN Tagging)
- IEEE 802.3ad (Link Aggregation)
- IEEE 802.3z Gigabit SX/LX
- IEEE 802.3 (10Base-T Ethernet)
- IEEE 802.3ab (Twisted Pair Gigabit Ethernet)
- IEEE 802.3ad (Link Aggregation Control Protocol LACP)
- IEEE 802.3af (Power over Ethernet 802.3at Type 1)
- IEEE 802.3at (Power over Ethernet 802.3at Type 2)
- IEEE 802.3bt (PoE++/4PPoE/Ultra Power over Ethernet)
- IEEE 802.3u (100Base-TX Fast Ethernet)
- IEEE 802.3x (flow control, for full-duplex mode)
General
- Ports
- Eight 10/100/1000 Mbps RJ45 PoE-enabled ports
- Two Gigabit SFP slots
- One console port - Media support:
- 10Base-T Cat5e UTP/STP RJ45, 8 pin
- 100Base-TX Cat5e UTP/STP RJ45, 8 pin
- 1000Base-T Cat5e UTP/STP RJ45, 8 pin - MAC address table: 8k
- Buffer memory: 4.1 Mbits
- Forwarding rate: 14.88 Mpps
- MTBF: 392,650 hours
- Backplane speed/switch fabric: 20 Gbps
- Switch architecture: store and forward
- Configuration options:
- Port link speed: 10 Mbps, 100 Mbps, 1000 Mbps or auto-negotiation
- PoE on/off per port
- PoE maximum power per port
- PoE mode per port
- PoE priority per port: low, medium, high
- PoE alarm notification via SNMP traps
- PoE delay start configuration per port
- PoE restart time configuration per port
- PoE status monitoring - PD monitor function, watch guard
- PoE Scheduling
- Flow control on/off per port
- VLAN
- Rate Limiting (ingress rate and egress rate)
- Port Mirroring, one-to-one or many-to-one
- Port Aggregation/LACP: 8 groups
- Broadcast Storm configuration with broadcast rate, multicast rate and flooded unicast rate
- IGMP Snooping
- Access management filtering: SNMP, HTTP, HTTPS, SSH, TELNET
- Quality of Service (QoS): CoS or DSCP
- Link Layer Discovery Protocol (LLDP)
- Integrated ICMP Ping client sends ping requests to other network nodes
- SNMPv1/v2c/v3 (Simple Network Management Protocol)
- RMON 1, 2, 3 and 9 groups (statistic, history, alarm and event)
- TACACS+ via command line
- Built-in RADIUS client to cooperate with the RADIUS servers
- Tracert utility
- Access Control List: MAC-based and IPv4/IPv6 IP-based ACL
- Built-in Trivial File Transfer Protocol (TFTP) client
- Dynamic ARP Inspection (DAI) discards ARP packets with invalid MAC-address to IP-address binding
- DoS attack prevention
- DHCP: Client/Option82/Snooping
- LAN settings (IP address, Gateway, etc.)
- SSHv2
- Certifications: FCC, CE, RoHS, UKCA, NDAA
LEDs
- PoE
- Power
- Link/Activity
Buttons
- Mode
- Reset
Pinout RJ45 output ports (PoE+ ports 1 - 6)
- Pin 1: DC (-)
- Pin 2: DC (-)
- Pin 3: DC (+)
- Pin 6: DC (+)
Pinout RJ45 output ports (PoE++ ports 7 - 8)
- Pin 1: DC (-)
- Pin 2: DC (-)
- Pin 3: DC (+)
- Pin 4: DC (+)
- Pin 5: DC (+)
- Pin 6: DC (+)
- Pin 7: DC (-)
- Pin 8: DC (-)
Power
- Input: 100.0 - 240.0 VAC, 50 - 60 Hz, internal power supply
- PoE power budget: 242.0 watts (max.)
- Power consumption: 252.0 W (max.)
Physical
- Metal housing
- Dimensions (L x W x H): 230 x 280 x 44 mm (9.06 x 11.02 x 1.73 in.)
- Net weight: 2.5 kg (5.51 lbs.)
- Gross weight: 2.65 kg (5.84 lbs.)
- Environmental
- Operating temperature: 0 - 45°C (32 - 113°F)
- Storage temperature: -40 - 70°C (-40 - 158°F)
- Operating humidity: 10 - 90% RH, non-condensing
- Storage humidity: 5 - 90% RH, non-condensing
Package Contents
- 10-Port L2+ Fully Managed PoE++ Switch with 8 Gigabit Ports and 2 SFP Uplinks
- Power cable
- Instructions
- 19" rackmount brackets
更多資訊
Additional SKUs
- Alphanumeric Part#: IPS-10GM02-242W
- Amazon ASIN: B0CQ2PXN5K
- EAN: 0766623562003
- UPC: 766623562003
Physical Specifications
- Product net weight: 2.5 kg
- Product gross weight: 2.65 kg
- Dimensions: 230 (L) x 280 (W) x 44 (H) [mm]
- Packaging: Retail Box